Cutting the cap of a cigar with the Toro Puro Precision Cigar Cutter

How to Cut a Cigar, in Plain Words

Nov 09, 2026

One small cut decides how the rest of the evening goes

Introduction

There is a moment before every cigar when you hold it, turn it in your fingers and look for the place to cut. It takes a second. It also decides how the cigar will draw, how it will burn and whether the wrapper holds together to the end.

Cutting is not difficult, but it rewards a little care. This guide covers where to cut, the three common cuts, which tools suit which cigar, and the mistakes almost everyone makes once.

Where to cut

Look at the head of the cigar, the closed end you will draw from. You will see a small round piece of leaf glued over the top. That is the cap, and it holds the wrapper in place. Just below it there is a faint line where the cap meets the body of the cigar.

Your cut belongs just above that line. On most cigars that means taking off about two millimetres. The aim is to open the cigar, not to shorten it. If you cut below the line, the cap has nothing left to hold and the wrapper can begin to loosen as you smoke.

Hold the cigar steady, place the blade, and make one firm, decisive cut. Hesitant, sawing cuts tear the leaf.

The three cuts

The straight cut. The most common and the most forgiving. A guillotine or a pair of cigar scissors removes a thin slice across the head. It opens the full width of the cigar and gives a generous draw. If you are unsure, start here.

The punch. A small circular blade presses a neat hole into the cap. It suits cigars with a rounded head and a medium ring gauge, keeps the cap intact and concentrates the draw. It is less suited to very thin cigars or pointed heads.

The V cut. A wedge shaped notch across the cap. It gives a deeper opening than a punch without removing the whole top. Some people like the way it focuses the smoke; others find it a little fussy. It is worth trying once.

For a cigar with a pointed head, such as a torpedo or a belicoso, use a straight cut and take only the very tip at first. You can always cut a little more. Our Montecristo No. 2 guide shows the shape well.

Choosing a cutter

A sharp blade matters more than a famous name. A blunt cutter crushes the head instead of slicing it, and a crushed head draws badly from the first puff.

A guillotine, like our Toro Puro Precision Cigar Cutter, keeps the cigar centred, and its built-in back stop means you cannot cut too deep: rest the cap against the stop, press, and the cut is done. Cigar scissors, such as the Fox Fígaro Cigar Cutter 747, give more control by hand and suit slimmer cigars, up to around 54 ring gauge. A folding cigar knife is the quiet, elegant option for those who carry one cutter for life; we explain why in our Les Fines Lames review.

You can see every option side by side in our cigar cutters collection.

The mistakes almost everyone makes once

Cutting too deep is the most common. The wrapper starts to unravel and there is no way back. Take less than you think.

Cutting in two hesitant motions is the second. It leaves a ragged edge that pulls at the lips and draws unevenly.

The third is forgetting to check the draw. After cutting, take a gentle draw without lighting. You should feel a light, even resistance, a little like drawing through a straw. If it feels tight, a second, thinner cut usually solves it.

After the cut

Once the head is open, the cigar is ready to light. Light slowly and evenly; our guide to lighting a cigar walks through each step, and The Ritual of Cutting, Lighting and Storing brings the whole sequence together.

Closing Thought

The cut is the smallest part of the ritual and the easiest to rush. Give it a second longer than you think it needs. The cigar will tell you, an hour later, that it was worth it.



More articles